PART IIInstallation
CHAPTER 5

Powerbar: your aquarium's outlets

The Powerbar V8 is the Aquarino's power distribution and control bar: eight outlets individually commanded by the hub. The Controller accepts two Powerbars, for a total of 16 outlets.

The Powerbar V8: eight individually controlled outlets.
The Powerbar V8: eight individually controlled outlets.

5.1 Installing

  1. Unplug your Aquarino from the wall.
  2. On the Powerbar, set the address switch: A for outlets 1 to 8, B for outlets 9 to 16.
  3. Connect the supplied network cable between the Powerbar and a BUS port on the hub.
  4. Connect the Powerbar's power cable to your mains supply (110 V or 220 V).
  5. Power the Aquarino back on.
  6. Confirm detection in System → System Status, in the Powerbar block.
CharacteristicValue
Outlets per Powerbar8
Powerbars per hub2 (switches A and B)
Supply voltage110 V or 220 V
Maximum load per Powerbar10 A
Communication cable2 m included; 5 m maximum
MountingHorizontal or vertical, with its own mounting holes