PART IIInstallation
CHAPTER 5

Installing the pH probe

The pH probe is delicate and needs careful handling. Set aside a few minutes and follow the steps calmly.

  1. Remove the silicone protective cap from the probe. Place the probe in a cup of water from your aquarium to rinse it.
  2. Connect the probe's BNC to the side input marked PH-IN.
  3. Carefully insert the probe into the measurement compartment of the Aquarino KH.
Step 1 — remove the protective cap and rinse the probe.
Step 1 — remove the protective cap and rinse the probe.
Step 2 — connect the BNC to the PH-IN input.
Step 2 — connect the BNC to the PH-IN input.
Step 3 — insert the probe into the measurement compartment.
Step 3 — insert the probe into the measurement compartment.